Search results
- [[category: Stepper Drive Control]]35 bytes (4 words) - 20:29, 12 May 2021
- [[category: Stepper Drive Control]]35 bytes (4 words) - 20:41, 12 May 2021
- * Two full H-bridges = four half H-bridges. That means you can drive four solenoids, two DC motors bi-directionally * Stepper Guide [[category: Stepper ]]2 KB (263 words) - 20:18, 12 May 2021
- ==Stepper Introduction== [[File:Stepper motor.jpg|300px]] [[File:Stepper motor 1.jpg|200px]]3 KB (572 words) - 20:56, 10 May 2021
- ...be moved an exact amount to print one letter after another. This is where stepper motors come in handy. ...nitty-gritty information. All you need to know for now is that, to move a stepper motor, you tell it to move a certain number of steps in one direction or th3 KB (455 words) - 20:03, 12 May 2021
- [[File:Unipolar stepper bb.jpg|thumbnail]] === Drive Board with DIR, STEP Pin (A3967, A4988) ===4 KB (522 words) - 14:45, 17 May 2021
- ...edundant. See [http://en.wikipedia.org/wiki/Stepper_motor wikipedia] and [[Stepper motor#Bipolar]] for more detailed information on unipolor vs. bipolor stepp ...vers are bipolar, so if you're using the standard drivers, you will need a stepper than can be wired as bipolar.9 KB (1,555 words) - 22:19, 10 May 2021
- * CLK+, CLK- pulse positive and negative terminals, need for control * Double check before to use, wrong wiring will burn the drive1 KB (206 words) - 17:09, 12 May 2021
- Stepstick Stepper Driver Board A4988 V2 03.png | A4988 Wiring Four, six, and eight-wire stepper motors can be driven by the A4988 if they are properly connected.<br />6 KB (957 words) - 19:59, 12 May 2021