F1C200S PROG

Flash Method

USB Sunxi-fel Programming

• Install driver from phoenix tools or Zadig
• Flash by sunxi-fel
• default debug Uart output port 1, PA2 PA3

SD Card Image Flash Method

• category: Linux Programming to TF Card

Firmware Image

phoenix tool

• It is a ready-only demo system
• CPU Boot Mode and Flash IMG to Target

• Flash software PhoenixSuit

Mode	TF Card	SD_NAND	SPI-Flash	Flash Target
PROG Mode	No Card	NC	SPI_CS -> GND Disable Flash Not Necessary if no SPI-Flash mounted	Flash Target
SPI-Flash Boot	No Card	NC	NC	Disconnect SPI_CS to flash SPI-Flash (connect SPI_Flash)
SD_NAND Boot	No Card	-> CS	-> GND (Optional? )	SD_NAND->CS to flash SD_NAND (connect SD_NAND)
TF Card Boot	Inserted Card	NC	-> GND (Not Necessary)	Insert TF card to flash TF card (connect TF Card)

Nano

• Support either SPI Flash or TF card boot
• For nano, find file folder Nano_Pub_V4 enter into build folder