TB6600

Use Guide TB6600, 6560

Note:

• Double check the wiring before to use, otherwise the module could be burnt.
• Do not use more than 3A motor

Wiring

• 

  Wiring Drive

• 

  Wiring Drive 2

• 

  Wiring Drive-MCU

• 

  Wiring Drive-MCU 2

• 

  Wiring Drive-Motor

Pin Definition

Name	Name2	Description	Mode
+24V, GND		Motor power
A+/-, B+/-		Motor phase A/B
CLK +/-	PUL +/-	Pulse
CW +/-	DIR +/-	Direction	Clockwise on H-TTL, vice serse
EN+ EN-	ENA, ENB	Enable	Standby/lock mode on H-TTL, vice serse

• CLK, CW and EN can be configured to work as high TTL or Low TTL
• Default TTL signal is 5V, If use 12V signal, serial connect a 1K resistor, if use 24V signal, serial connect a 2.4K resistor

Configuration TB6560

• 

  TB6560 Board Print

• 

  TB6560 Step Division

• 

  TB6600 Step Configuration

Dimension

• 

  TB6600 Module Dimension

Quick Start and Troubleshoot

• Use accelStepper library, modified demo code please check git-hub page here.
• No need to connect EN at beginning
• When alarm light up, double check voltage too small or big, double check motor wiring. Normally 16 division micro-setp can work well.
• Check demo video, if all wiring correct, double check or try division of micro-step.