Drawing Machine
Introduction
- Project revised from Axidraw, 4xidraw
- Demo video please see on this page.
Installation
BOM List
Electronics Parts
- Arduino UNO Board
- Arduino CNC shield
- 2x A4988 Drive
- 2x Minebea NEMA-17 (42mm) stepper
- 1x SG90 Serve Motor
- 2x Stepper cables, 1m
- 1x servo 3 pins cable 0.5m
Mechanical Parts
- 2x X-end (3d printer)
- 1x Y1-end (3d printer)
- 1x Y2-end (3d printer)
- 1x X-Y-Top (3d printer)
- 1x X-Y-Bottom (3d printer)
- 1x pen-holder-servo-holder (3d printer)
- 1x pen-holder-solider (3d printer)
- 1x pen-holder-holder (3d printer)
- 2x synchronous gear (pre-assemabled), synchronous belt
- Accesseries: linear bearing, M5 screws, all of it.
Tool you need
- M5 hexagon screwdriver
- M3 hexagon screwdriver
NOT Included
- 2020 Beam - Aluminium extrusion profile
- Linear Motion Rod dia. 8 mm x 406mm Shaft
Installation guide
1. X-Y
2. Y1 End
3. Y1 End
4. X End
5. Pen-holder
6. Fully assemble
Software Use Guide
- Arduino Firmware - First upload arduino gbrl firmware, complied hex file.
- Use Grbl controller open serial, on rate 115200
- Use standard gcode file and guide from here CNC.
Final Drawing Note
- Keep table horizontal
- Add weight on pen holder to make sure the pen fully well touched paper
- Make sure nothing around the machine, X Y axis should be able to more to maxmium and not have any obstacles