Category:ESP8285

From ElectroDragon Wiki
Revision as of 13:38, 24 October 2019 by Chao (talk | contribs) (Created page with "==Breakout Board== * Front pins: GPIO12 GPIO13 GPIO14 GPIO4 GPIO5 GPIO15 * Back pins: GPIO16 GPIO0 GND TX RX VCC * Pin arrangement for default firmware: # GPIO13(D4) control t...")
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)

Breakout Board

  • Front pins: GPIO12 GPIO13 GPIO14 GPIO4 GPIO5 GPIO15
  • Back pins: GPIO16 GPIO0 GND TX RX VCC
  • Pin arrangement for default firmware:
  1. GPIO13(D4) control the 1st relay
  2. GPIO12(D5) control the 2nd relay (pull up)
  3. GPIO14(D6) control the 3rd relay
  4. GPIO16(D7) control the 4th relay
  5. GPIO4 (D8) control the 5th relay

Schematic

Esp8285 schematic 02.jpg

Embedded Soldering

  • 01

  • 02

Firmware note

Esp8285 flash.png
  • Change SPI mode to DOUT, flash to 8MBit, should esp8266 normal at commands firmware or nodemcu, mostly same.


Reference Link

Documents

This category currently contains no pages or media.

Retrieved from "http://w.electrodragon.com/w/index.php?title=Category:ESP8285&oldid=23062"