Arduino Pro mini

Usage

• For wiring, our EDarduino pro mini works good with our FTDI basic, you only need to connect them together and to your PC USB port.
• For driver, you need to install both FTDI board driver firstly and then pro mini driver further, so you should have two drivers installed
• Finally you should see the com port availabe in arduino IDE, and available to program.
• upload the blink sketch, you see the LED 13 on the right of the front of the board, and power led in the middle of the board.

BOM

• Schematic see category: Arduino Boards page

This BOM list is not yet typeset, please click the "source" of this page on the right top and copy/paste into notepad

1. Part Value Package Library Position (inch) Orientation
2. C1 0.1uF C0402 SparkFun (0.525 0.365) R180
3. C2 0.1uF C0402 SparkFun (0.125 1.1) R90
4. C3 0.1uF C0402 SparkFun (0.525 0.31) R180
5. C10 0.1uF C0402 SparkFun (0.235 0.78) R90
6. C13 10uF EIA3216 SparkFun (0.2 0.95) R90
7. C19 10uF EIA3216 SparkFun (0.53 0.95) R90
8. D3 Green LED-0603 SparkFun (0.55 0.1) R180
9. JP1 FTDI Basic 1X06 SparkFun (0.1 1.25) MR180
10. JP2 1X02 SparkFun (0.55 0.7) MR90
11. JP6 1X12 SparkFun (0.65 1.15) MR270
12. JP7 1X12 SparkFun (0.05 0.05) MR90
13. LED1 Red LED-0603 SparkFun (0.35 0.85) R270
14. Q1 #MHz RESONATOR-SMD SparkFun (0.15 0.765) R90
15. R2 10K C0402 SparkFun (0.2 0.15) R90
16. R6 330 C0402 SparkFun (0.55 0.2) R270
17. R11 10K C0402 SparkFun (0.35 1.05) R180
18. S2 Reset TACTILE_SWITCH_SMD SparkFun (0.35 0.15) R180
19. U$2 FIDUCIAL1X2 FIDUCIAL-1X2 SparkFun (0.5 0.15) R0
20. U$4 FIDUCIAL1X2 FIDUCIAL-1X2 SparkFun (0.2 1.15) R0
21. U1 ATMEGA168# TQFP32-08 SparkFun (0.35 0.55) R315
22. U2 ###V SOT23-5 SparkFun (0.35 0.95) R90

Reference

Quick Start Guide