RPI RMP HDK

Quick Setup

• You can leave the RTC and battery for beginning, it not necessary to drive the RGB matrix panel.
• Switch can turn to P3 chain side to enable P3 HUB75 output.
• To drive one panel, connect P1 Port to your panel HUB "IN"
• Supply Power at least 3-5A 5V to LED panel.

• Double check your panel specifications, we only support for our type panels. Different panel specification may need revise the code.

Board schematic, Functions

• 

  Board schematic

• 

  Board Pin Definitions

• To use RTC DS1307, please don't forget to turn on IIC interface in "raspi-config", and switch turn to up.
• IIC interface can leave on if not used P3, when you only use P2 and P3

• Notice more about the customize version issue before ordering - https://github.com/hzeller/rpi-rgb-led-matrix/issues/797

Detailed Pin Definitions

• ROW_A = 22
• ROW_B = 23
• ROW_C = 24
• ROW_D = 25
• ROW_E = GPIO 15
• OE = GPIO 18
• CLK = GPIO 17
• LAT (STROKE) = GPIO 4
• P0 R1/G1/B1 = 11 / 27 / 26
• P0 R2/G2/B2 = 8 / 9 / 10

• P1 R1/G1/B1 = 12 / 5 / 6
• P1 R2/G2/B2 = 19 / 13 / 20

• P2 R1/G1/B1 = 8 / 2 / 3
• P2 R2/G2/B2 = 26 / 16 / 21

Setup E-Line

• E-Line buffer to either PIN4 or PIN8
• refer to the image