TB6560

SPECS

• 1) The working voltage is DC 10V-35V. It is recommended to use a switching power supply DC24V for power supply.
• 2) The use of 6N137 high-speed optical coupling to ensure high speed without losing step.
• 3) Adopt brand-new TB6560AHQ chip, with built-in low-voltage shutdown, overheating shutdown and overcurrent protection circuits to ensure performance.
• 4) The rated output is: ±3A, with a peak value of 3.5A.
• 5) It is suitable for two-phase/four-phase/four-wire/six-wire stepping motor with 42,57 stepping within 3A, not suitable for stepping motor with more than 3A.
• 6) Automatic half-flow function.
• 7) Subdivision: full step, half step, 1/8 step, 1/16 step, 16 subdivision.
• 8) Volume: width 50 * length 75 * height 35 (MM)

Wirings

• +24V, GND Power supply positive and negative
• A+, A- motor phase A
• B+, B- motor phase B

• CLK+, CLK- pulse positive and negative terminals， need for control
• CW+, CW- direction positive and negative ends, can be left for NC
• EN+, EN- enable positive and negative terminals, can be left for NC

Setup

• 

  wiring 02

• 

  wiring 03

• Excitation Mode 细分设置
• Decay settings 衰减模式
• Stop Current 静止时半流模式
• Running Current 运行电流

Note

• Double check before to use, wrong wiring will burn the drive
• EN+ to low or NC for running mode!