OLED HDK
SSD1306 and SSH1106
- IIC address select, 稳压管 = on board regulator
- IC compare
| Type | SSH1106 | SSD1306 |
|---|---|---|
| Display | for 1.3 only | for 0.96 and 1.3 both |
| RAM / resolution | 132 x 64 | 128 x 64 |
| address | 0x00 | 0x02 |
| Alternative address for arduino | 0x3D or 0x3C, or run a IIC scanner in arduino |
Interface - IIC
- GND VCC SCL SDA
- And here is the front side of display
Interface - SPI
- GND - GND
- VCC - 3.3V - 5V
- CLK or D0 - SPI_CLK
- MOSI or D1 - SPI_MOSI
- RES - Reset (normal MCU IO)
- DC - Data / Command (normal MCU IO)
- CS - SPI_CS
Interface
| Pin From Left | IIC | SPI | Change from SPI to IIC | Arduino Setup |
|---|---|---|---|---|
| 1 | GND | GND | GND | |
| 2 | VCC | VCC | VCC | |
| 3 | SCL | D0 - CLK or SCL | D13 | |
| 4 | SDA | D1 - MOSI or SDA | D11 | |
| 5 | X | reset | D8 | |
| 6 | X | data/command select | for setting IIC address | D9 |
| 7 | X | chip select | D10 |
- SPI interface, can be changed to IIC
- To use SPI un-comment U8G2 library line in skech example
U8X8_SH1106_128X64_NONAME_4W_HW_SPI u8x8(/* cs=*/ 10, /* dc=*/ 9, /* reset=*/ 8);
- To use IIC, un-commen the next line
U8X8_SH1106_128X64_NONAME_HW_I2C u8x8(/* reset=*/ U8X8_PIN_NONE);
Dimension
Dimension for OLED with back PCB
0.96 SPI OLED dimension
0.96 IIC OLED dimension
0.96 IIC OLED 02 dimension
1.3_OLED_dimension
1.3 OLED dimension IIC new, for SPI and IIC both
Dimension for raw OLED, see more information in raw oled datatsheet below
0.86 raw oled dimension
0.91 raw oled dimension
Board schematic
RAW OLED schematic
Left side for 5V system compliant, middle is reset (without IOs), address select, OLED and passive parts on right
Schematic wiring for Raspberry
For raspberry Pi
SH1106 IIC
SH1106 SPI
SSD1306 IIC
SSD1306 SPI
SSD1306 SPI R2, supported to change to IIC
0.91 SSD1306 schematic
Common Version
- 0.96" = 128x64
- 1.3" = 128x64
- 0.91" = 128x32