ESPeasy

From ElectroDragon Wiki
  • Espeasy can easily read the sensor value, support mutiple protocols like domoticz, openhab
  • File:ESPEasy R120.zip , upload
  • Restart board and connect to AP point esp_0, config to your wifi router, notice the new IP address of board will popup after config, read more about setup espeasy here.

For DHT22 Sensor on ESP Relay Board

Setup DHT22 sensor

  • Place DHT22 sensor into board, "as how it looks like", just fit the place
  • In device config page, device -> see attached image
  • In device config page, hardware -> set GPIO14 to input
  • Domoticz hardware setup of IDX/VAR for DHT22 normally is 237, switch relay is 100, this must be input, otherwise won't work


  • setup

  • and then value show up

Retrieved from "http://w.electrodragon.com/w/index.php?title=ESPeasy&oldid=28037"