- Thermistor output resistive and convert to voltage
- LM35, LM75
- AM Sensor
- Thermocouple (output mV)
- Maxim DS1621 SOP-8, DS18B20
- BMP280, BME280 category: Pressure sensor
- STH31-D / SHT20 / SHT10
DS18B20 Waterproof Version Debug Note
- For arduino, use 3.3V is more sensittive than 5V.
- Note to add 1~10K pull up resistor between data pin and VCC
- If can not read out data properly, try to remove power VCC and GND, and reconnect them again.
This category has the following 4 subcategories, out of 4 total.
Pages in category "Temperature Sensor"
The following 10 pages are in this category, out of 10 total.