|
|
| Line 1: |
Line 1: |
|
| |
|
| == Programmer ==
| |
| ==== ST-LINK + ST Utility ====
| |
| * [[ST-Link]]
| |
|
| |
|
| ==== [[DAPLink]] ====
| |
| * Moved to this page [[DAPLink]]
| |
|
| |
|
| ==== Jlink, JTAG ====
| |
| * [[JLink]]
| |
|
| |
| == Embedded bootloader ==
| |
| The embedded bootloader mode is used to reprogram the Flash memory using one of the following serial interfaces:
| |
| * SWD Default
| |
| * USART1 (PA9/PA10)
| |
| * USART3 (PB10/11 and PC10/11)
| |
| * CAN2 (PB5/13)
| |
| * USB OTG FS (PA11/12) in Device mode (DFU: device firmware upgrade).
| |
|
| |
|
|
| |
|
| Line 23: |
Line 8: |
| [[File:Stm32_serial_wiring_02.jpg|400px]] | | [[File:Stm32_serial_wiring_02.jpg|400px]] |
|
| |
|
| === DFU USB OTG ===
| |
| * Listed supported device in ST documents [https://www.st.com/content/ccc/resource/technical/document/application_note/6a/17/92/02/58/98/45/0c/CD00264379.pdf/files/CD00264379.pdf/jcr:content/translations/en.CD00264379.pdf AN3156]
| |
| [[File:DFU.gif|thumbnail|right]]
| |
| * Download [http://www.st.com/en/development-tools/stsw-stm32080.html DfuSe USB device firmware upgrade (DFU) software]
| |
| * Install the drive in installation folder -C:\Program Files (x86)\STMicroelectronics\Software\DfuSe v3.0.5\Bin\Driver or here [[File:STM-Bootloader-Driver.zip|STM32 Bootloader Driver]]
| |
| * Testing firmware for [[:File:Can-usb.zip|USB-CAN here]].
| |
| * Open the DFU tool to upload firmware to internal flash, see left animation.
| |
|
| |
|
| === ISP USART === | | === ISP USART === |
| Line 41: |
Line 19: |
| </gallery> | | </gallery> |
|
| |
|
|
| |
| == Debug ==
| |
| * If SWD Serial-Wire is not enable, add reset line to force enter into debug mode
| |
|
| |
|
| [[category: STM32 SDK]] | | [[category: STM32 SDK]] |
Revision as of 17:33, 5 July 2024
