|
|
| (4 intermediate revisions by the same user not shown) |
| Line 1: |
Line 1: |
| | | https://w2.electrodragon.com/gollum/search?q=stm32-dat.md |
| == Programmer ==
| |
| ==== ST-LINK + ST Utility ====
| |
| * [[ST-Link]]
| |
| | |
| ==== [[DAPLink]] ====
| |
| * Moved to this page [[DAPLink]]
| |
| | |
| ==== Jlink, JTAG ====
| |
| * [[JLink]]
| |
| | |
| == Embedded bootloader ==
| |
| The embedded bootloader mode is used to reprogram the Flash memory using one of the following serial interfaces:
| |
| * SWD Default
| |
| * USART1 (PA9/PA10)
| |
| * USART3 (PB10/11 and PC10/11)
| |
| * CAN2 (PB5/13)
| |
| * USB OTG FS (PA11/12) in Device mode (DFU: device firmware upgrade).
| |
| | |
| | |
| === SWD ===
| |
| === Hardware Interface ===
| |
| [[File:Stm32_serial_wiring_02.jpg|400px]]
| |
| | |
| === DFU USB OTG ===
| |
| * Listed supported device in ST documents [https://www.st.com/content/ccc/resource/technical/document/application_note/6a/17/92/02/58/98/45/0c/CD00264379.pdf/files/CD00264379.pdf/jcr:content/translations/en.CD00264379.pdf AN3156]
| |
| [[File:DFU.gif|thumbnail|right]]
| |
| * Download [http://www.st.com/en/development-tools/stsw-stm32080.html DfuSe USB device firmware upgrade (DFU) software]
| |
| * Install the drive in installation folder -C:\Program Files (x86)\STMicroelectronics\Software\DfuSe v3.0.5\Bin\Driver or here [[File:STM-Bootloader-Driver.zip|STM32 Bootloader Driver]]
| |
| * Testing firmware for [[:File:Can-usb.zip|USB-CAN here]].
| |
| * Open the DFU tool to upload firmware to internal flash, see left animation.
| |
| | |
| === ISP USART === | |
| * BOOT0 should be pull to high, foce chip into system memory
| |
| * Flash loader demostrator from official ST = Flasher
| |
| * https://www.st.com/en/development-tools/flasher-stm32.html
| |
| <gallery>
| |
| File:Flash_demonstrator_01.png | Use guide 01
| |
| File:Flash_demonstrator_02.png | Select memory size
| |
| File:Flash_demonstrator_03.png | upload code
| |
| </gallery>
| |
| | |
| | |
| == Debug ==
| |
| * If SWD Serial-Wire is not enable, add reset line to force enter into debug mode
| |
| | |
| [[category: STM32 SDK]]
| |