https://w.electrodragon.com/w/index.php?action=history&feed=atom&title=TB6560TB6560 - Revision history2026-06-04T20:00:56ZRevision history for this page on the wikiMediaWiki 1.37.2https://w.electrodragon.com/w/index.php?title=TB6560&diff=30982&oldid=prevChao at 09:09, 12 May 20212021-05-12T09:09:37Z<p></p>
<p><b>New page</b></p><div>[[File:TB6560 WIRING 01.png|thumb|right]]<br />
== SPECS ==<br />
* 1) The working voltage is DC 10V-35V. It is recommended to use a switching power supply DC24V for power supply.<br />
* 2) The use of 6N137 high-speed optical coupling to ensure high speed without losing step.<br />
* 3) Adopt brand-new TB6560AHQ chip, with built-in low-voltage shutdown, overheating shutdown and overcurrent protection circuits to ensure performance.<br />
* 4) The rated output is: ±3A, with a peak value of 3.5A.<br />
* 5) It is suitable for two-phase/four-phase/four-wire/six-wire stepping motor with 42,57 stepping within 3A, not suitable for stepping motor with more than 3A.<br />
* 6) Automatic half-flow function.<br />
* 7) Subdivision: full step, half step, 1/8 step, 1/16 step, 16 subdivision.<br />
* 8) Volume: width 50 * length 75 * height 35 (MM)<br />
<br />
== Wirings ==<br />
* +24V, GND Power supply positive and negative<br />
* A+, A- motor phase A<br />
* B+, B- motor phase B<br />
<br />
* CLK+, CLK- pulse positive and negative terminals， need for control<br />
* CW+, CW- direction positive and negative ends, can be left for NC<br />
* EN+, EN- enable positive and negative terminals, can be left for NC<br />
<br />
== Setup ==<br />
<gallery><br />
File:TB6560_WIRING_02.png | wiring 02<br />
File:TB6560_WIRING_03.png | wiring 03<br />
</gallery><br />
* Excitation Mode 细分设置<br />
* Decay settings 衰减模式<br />
* Stop Current 静止时半流模式<br />
* Running Current 运行电流<br />
<br />
<br />
== Note ==<br />
* Double check before to use, wrong wiring will burn the drive<br />
* EN+ to low or NC for running mode!<br />
<br />
[[category: Stepper Drive]]</div>Chao