Chao at 04:42, 26 May 2020

2020-05-26T04:42:52Z

New page

== Boot ==
<source lang="text">
NUC970 IBR 20151008.1735
No Key
Boot from NAND
nand_boot

U-Boot 2013.04-rc2 (Apr 25 2017 - 10:51:57)

CPU: NUC972
DRAM: 64 MiB
NAND: 128 MiB
MMC: mmc: 0
In: serial
Out: serial
Err: serial
Net: emac
Hit any key to stop autoboot: 0

Loading from nand0, offset 0x200000
Image Name:
Image Type: ARM Linux Kernel Image (uncompressed)
Data Size: 6254944 Bytes = 6 MiB
Load Address: 00007fc0
Entry Point: 00008000
## Booting kernel from Legacy Image at 00007fc0 ...
Image Name:
Image Type: ARM Linux Kernel Image (uncompressed)
Data Size: 6254944 Bytes = 6 MiB
Load Address: 00007fc0
Entry Point: 00008000
Verifying Checksum ... OK
SF: Detected W25Q128 with page size 4 KiB, total 16 MiB
SF: DeviceBooting Linux on physical CPU 0x0
Initializing cgroup subsys cpuset
Initializing cgroup subsys cpu
Initializing cgroup subsys cpuacct
Linux version 3.10.101 (sinc@sinc-virtual-machine) (gcc version 4.5.1 (Sourcery G++ Lite 2010.09-50) ) #13 PREEMPT Thu Aug 18 16:00:37 CST 2016
CPU: ARM926EJ-S [41069265] revision 5 (ARMv5TEJ), cr=00053177
CPU: VIVT data cache, VIVT instruction cache
Machine: NUC970
Memory policy: ECC disabled, Data cache writeback
Built 1 zonelists in Zone order, mobility grouping on. Total pages: 16256
Kernel command line: root=/dev/ram0 console=ttyS0,115200n8 rdinit=/sbin/init mem=64M
PID hash table entries: 256 (order: -2, 1024 bytes)
Dentry cache hash table entries: 8192 (order: 3, 32768 bytes)
Inode-cache hash table entries: 4096 (order: 2, 16384 bytes)
Memory: 64MB = 64MB total
Memory: 58568k/58568k available, 6968k reserved, 0K highmem
Virtual kernel memory layout:
vector : 0xffff0000 - 0xffff1000 ( 4 kB)
fixmap : 0xfff00000 - 0xfffe0000 ( 896 kB)
vmalloc : 0xc4800000 - 0xff000000 ( 936 MB)
lowmem : 0xc0000000 - 0xc4000000 ( 64 MB)
modules : 0xbf000000 - 0xc0000000 ( 16 MB)
.text : 0xc0008000 - 0xc04a21b4 (4713 kB)
.init : 0xc04a3000 - 0xc05c0f5c (1144 kB)
.data : 0xc05c2000 - 0xc05ff160 ( 245 kB)
.bss : 0xc05ff160 - 0xc0633f88 ( 212 kB)
SLUB: HWalign=32, Order=0-3, MinObjects=0, CPUs=1, Nodes=1
Preemptible hierarchical RCU implementation.
NR_IRQS:625
sched_clock: 32 bits at 100 Hz, resolution 10000000ns, wraps every 4294967286ms
Console: colour dummy device 80x30
console [ttyS0] enabled
Calibrating delay loop... 148.88 BogoMIPS (lpj=744448)
pid_max: default: 32768 minimum: 301
Mount-cache hash table entries: 512
Initializing cgroup subsys devices
Initializing cgroup subsys freezer
Initializing cgroup subsys perf_event
CPU: Testing write buffer coherency: ok
Setting up static identity map for 0xc039c5b8 - 0xc039c5f4
devtmpfs: initialized
pinctrl core: initialized pinctrl subsystem
NET: Registered protocol family 16
DMA: preallocated 256 KiB pool for atomic coherent allocations
bio: create slab <bio-0> at 0
SCSI subsystem initialized
usbcore: registered new interface driver usbfs
usbcore: registered new interface driver hub
usbcore: registered new device driver usb
Advanced Linux Sound Architecture Driver Initialized.
Switching to clocksource nuc970-timer1
cfg80211: Calling CRDA to update world regulatory domain
NET: Registered protocol family 2
TCP established hash table entries: 512 (order: 0, 4096 bytes)
TCP bind hash table entries: 512 (order: -1, 2048 bytes)
TCP: Hash tables configured (established 512 bind 512)
TCP: reno registered
UDP hash table entries: 256 (order: 0, 4096 bytes)
UDP-Lite hash table entries: 256 (order: 0, 4096 bytes)
NET: Registered protocol family 1
NetWinder Floating Point Emulator V0.97 (double precision)
ROMFS MTD (C) 2007 Red Hat, Inc.
msgmni has been set to 114
Block layer SCSI generic (bsg) driver version 0.4 loaded (major 252)
io scheduler noop registered
io scheduler deadline registered
io scheduler cfq registered (default)
fb0: nuc970fb frame buffer device
nuc970-uart.0: ttyS0 at I/O 0x0 (irq = 36) is a NUC970
nuc970-uart.1: ttyS1 at I/O 0x0 (irq = 37) is a NUC970
nuc970-uart.2: ttyS2 at I/O 0x0 (irq = 38) is a NUC970
nuc970-uart.3: ttyS3 at I/O 0x0 (irq = 43) is a NUC970
nuc970-uart.5: ttyS5 at I/O 0x0 (irq = 44) is a NUC970
nuc970-uart.9: ttyS9 at I/O 0x0 (irq = 46) is a NUC970
brd: module loaded
nuc970 mtd nand driver version: 20160331
NAND device: Manufacturer ID: 0xc2, Chip ID: 0xf1 (Macronix NAND 128MiB 3,3V 8-bit), 128MiB, page size: 2048, OOB size: 64
SYSTEM: USE BCH_T4 HWECC algorithm(SMRA size: 64, Parity number:32 bytes)
EXECUTE: USE BCH_T4 HWECC algorithm(SMRA size: 64, Parity number:32 bytes)
USE BCH_T4 HWECC algorithm(Parity number:32 bytes)
Bad block table not found for chip 0
Bad block table not found for chip 0
Scanning device for bad blocks
Bad block table written to 0x000007fe0000, version 0x01
Bad block table written to 0x000007fc0000, version 0x01
Creating 7 MTD partitions on "nand0":
0x000000000000-0x000000080000 : "u-boot-spl"
0x000000080000-0x000000100000 : "u-boot-env"
0x000000100000-0x000000280000 : "u-boot"
0x000000280000-0x000001300000 : "Kernel"
0x000001300000-0x000001600000 : "logo"
0x000001600000-0x000003600000 : "root"
0x000003600000-0x000008000000 : "home"
fmi-sm: registered successfully! mtdid=nand0
CAN device driver interface
nuc970-can0 nuc970-can0: nuc970_can0_platform device registered (regs=f800b000, irq=58)
libphy: nuc970_rmii0: probed
nuc970-emac0 nuc970-emac0: phy_find_first() failed
nuc970-emac0 nuc970-emac0: nuc970_mii_setup err
libphy: nuc970_rmii1: probed
nuc970-emac1 nuc970-emac1: phy_find_first() failed
nuc970-emac1 nuc970-emac1: nuc970_mii_setup err
ehci_hcd: USB 2.0 'Enhanced' Host Controller (EHCI) Driver
nuc970-ehci nuc970-ehci: Nuvoton NUC970 EHCI Host Controller
nuc970-ehci nuc970-ehci: new USB bus registered, assigned bus number 1
nuc970-ehci nuc970-ehci: irq 23, io mem 0xb0005000
nuc970-ehci nuc970-ehci: USB 2.0 started, EHCI 0.95
hub 1-0:1.0: USB hub found
hub 1-0:1.0: 2 ports detected
ohci_hcd: USB 1.1 'Open' Host Controller (OHCI) Driver
0x204 = 0x0
nuc970-ohci nuc970-ohci: Nuvoton NUC970 OHCI Host Controller
nuc970-ohci nuc970-ohci: new USB bus registered, assigned bus number 2
nuc970-ohci nuc970-ohci: irq 24, io mem 0xb0007000
hub 2-0:1.0: USB hub found
hub 2-0:1.0: 2 ports detected
usbcore: registered new interface driver usb-storage
mousedev: PS/2 mouse device common for all mice
input: NUC970 TouchScreen(ADC) as /devices/platform/nuc970-adc/input/input0
nuc970-rtc nuc970-rtc: rtc core: registered nuc970-rtc as rtc0
i2c /dev entries driver
nuc970-i2c0 nuc970-i2c0: deal with arbitration loss
arb lost, stop
nuc970-i2c0 nuc970-i2c0: timeout waiting for bus idle
rtc-isl1208 0-006f: chip found, driver version 0.3
nuc970-i2c0 nuc970-i2c0: deal with arbitration loss
nuc970-i2c0 nuc970-i2c0: deal with arbitration loss
arb lost, stop
...
rtc-isl1208 0-006f: rtc core: registered rtc-isl1208 as rtc1
nuc970-i2c0 nuc970-i2c0: deal with arbitration loss
nuc970-i2c0 nuc970-i2c0: deal with arbitration loss
arb lost, stop
...
usbcore: registered new interface driver usbhid
usbhid: USB HID core driver
nuc970-i2c0 nuc970-i2c0: deal with arbitration loss
nuc970-i2c0 nuc970-i2c0: deal with arbitration loss
arb lost, stop
nuc970-audio nuc970-audio: nau8822-hifi <-> nuc970-audio-i2s mapping ok
TCP: cubic registered
NET: Registered protocol family 17
can: controller area network core (rev 20120528 abi 9)
NET: Registered protocol family 29
can: raw protocol (rev 20120528)
can: broadcast manager protocol (rev 20120528 t)
can: netlink gateway (rev 20130117) max_hops=1
lib80211: common routines for IEEE802.11 drivers
nuc970-rtc nuc970-rtc: hctosys: unable to read the hardware clock
nuc970-i2c0 nuc970-i2c0: deal with arbitration loss
ALSA device list:
#0: nuc970_IIS
Freeing unused kernel memory: 1140K (c04a3000 - c05c0000)
yaffs: dev is 32505861 name is "mtdblock5" rw
yaffs: passed flags "inband-tags"
yaffs: dev is 32505862 name is "mtdblock6" rw
yaffs: passed flags "inband-tags"
/etc/init.d/rcS: .: line 21: can't open '/root/etc/rc.init'
</source>

== Category ==
=== Bin ===
<source lang="text">
~ # cd bin
/bin # ls
addgroup dd gzip mkdir pwd tar
adduser df hostname mknod rm touch
ash dmesg hush mktemp rmdir true
busybox dumpkmap ip more run-parts umount
cat echo iprule mount sed uname
catv egrep kill msh sh uncompress
chmod false lash mv sleep usleep
chown fgrep ln netstat stat vi
cp getopt login pidof stty watch
cpio grep ls ping su wc
date gunzip mdev ps sync zcat

</source>
[[category: NUC970]]

NUC972 Log - Revision history

Chao at 04:42, 26 May 2020