Chao at 20:28, 5 February 2020

2020-02-05T20:28:14Z

New page

== Use guide ==
'''Power on ->"normal mode"'''
* Read last config from MCU
* Start to count, when count to 0, turn on relay
* LONG press bottom button -> enter into the config mode of "turn on relay"
'''In the config mode for "the stage of active relay"'''
* Short press top button to add one second
* Short press bottom button to add 50 seconds
* Long press bottom button to enter into next the config mode of "turn off relay "
'''In the config mode for "the stage of deactive relay"'''
* Short press top button to add one second
* Short press bottom button to add 50 seconds
* Long press bottom button to save data, and back to "normal mode"
* Notice when deactive time set to 0 second, will hold the loop, won't quit
== Button Setup ==
{| class="wikitable sortable"
|-
! Board Type !! Config Button !! Add seconds button
|-
| STC Relay Board || P31 || P30
|-
| N76E003 Relay Board || P04 || P10
|-
| N76E003 Mosfet Board|| DOWN(P04) || UP(P10)
|}
Relay Board buttons: P04 hold to enter into config mode, P10 to add seconds.
== Schematic ==
<gallery>
File:STC_Relay_Board_sch.png | STC Relay Board SCH
</gallery>

== Setup Demo ==
* [https://twitter.com/electro_phoenix/status/996246067053285377 Clear Demo Video]
* [https://twitter.com/electro_phoenix/status/988328062084317184 A rough demo video for STC MCU relay board could see here], module count down and hold relay status on first loop, then config and loop as configed.
*
[[category: Relay]]

MCU Relay - Revision history

Chao at 20:28, 5 February 2020