Chao: Created page with "== Function and Mode == === Data Transmission Mode ROLE0 and ROLE1=== Slave Mode * AT+ROLE0 * AT+RESET Master Mode * AT+ROLE1 * AT+RESET * search slave module: AT+INQ 输..."

2021-05-21T09:30:59Z

Created page with "== Function and Mode == === Data Transmission Mode ROLE0 and ROLE1=== Slave Mode * AT+ROLE0 * AT+RESET Master Mode * AT+ROLE1 * AT+RESET * search slave module: AT+INQ 输..."

New page

== Function and Mode ==

=== Data Transmission Mode ROLE0 and ROLE1===
Slave Mode
* AT+ROLE0
* AT+RESET
Master Mode
* AT+ROLE1
* AT+RESET
* search slave module: AT+INQ
输出搜索到的从机 MAC、RSSI、NAME 参数
+DEV:0=11891240001F,,-28,JDY-24M
+DEV:1='''118912400020''',-46,JDY-24M
+DEV:2=118912400021,-26,JDY-24M
+DEV:3=11FA12400022,-40,JDY-34-BLE
* Connect it: AT+CONA118912400020

=== Mesh Function ===
* Turn off learning mode = AT+LEARN0
* Set to Mesh mode = AT+ROLE5, reset device = AT+RESET
* Configure the network NETID as 1122: AT+NETID1122
* Configure the current device short address as 0005: AT+MADDR0005
* Configure the device as a routing node: AT+MCLSS0
* Then configure the current KEY1 broadcast to control the OUT3 output of all devices in the network IO: AT+KEY1,0008,3,1
AT+KEY1,0008,3,1 = current input pin 1, target address 0008, target output pin 3, serial print enable 1

* Send AT+RESET again to restart to take effect, then KEY1 can control the output IO level of all OUT3 in the network.

[[category: JDY-25M]]

JDY-25M SDK - Revision history

Chao: Created page with "== Function and Mode == === Data Transmission Mode ROLE0 and ROLE1=== Slave Mode * AT+ROLE0 * AT+RESET Master Mode * AT+ROLE1 * AT+RESET * search slave module: AT+INQ 输..."