https://w.electrodragon.com/w/index.php?action=history&feed=atom&title=ESPeasyESPeasy - Revision history2026-06-08T13:21:19ZRevision history for this page on the wikiMediaWiki 1.37.2https://w.electrodragon.com/w/index.php?title=ESPeasy&diff=28037&oldid=prevChao at 07:27, 17 September 20202020-09-17T07:27:34Z<p></p>
<p><b>New page</b></p><div><br />
* Espeasy can easily read the sensor value, support mutiple protocols like domoticz, openhab<br />
* [[File:ESPEasy_R120.zip|Use eapeasy R120 version file "ESPEasy_R120_1024"]] , upload<br />
* Restart board and connect to AP point esp_0, config to your wifi router, notice the new IP address of board will popup after config, read more about setup espeasy [https://www.letscontrolit.com/wiki/index.php/EasySetup here].<br />
== For DHT22 Sensor on ESP Relay Board ==<br />
Setup DHT22 sensor<br />
* Place DHT22 sensor into board, "as how it looks like", just fit the place<br />
* In device config page, device -> see attached image<br />
* In device config page, hardware -> set GPIO14 to input<br />
* Domoticz hardware setup of IDX/VAR for DHT22 normally is 237, switch relay is 100, this must be input, otherwise won't work<br />
<br />
<br />
<gallery><br />
File:Espeasy_dht22_setup.png | setup<br />
File:Espeasy_dht22_value.png | and then value show up<br />
</gallery><br />
<br />
[[category: ESP8266 Firmware]]</div>Chao