Chao at 18:47, 5 February 2020

2020-02-05T18:47:25Z

New page

==Working Mode ==
* M1: Medium Power Saving mode, default mode for EC11.
* M2: Lowest Power Saving mode, 80ua standby current, high delay 400ms, baud rate only support 1200-4800, data can only transfer 256 bytes per packet due to high delay. Great for lower energry request projects.
* M3: Full Speed mode, delay down to below 8ms.
* M4: High Distance mode, the lower baud rate, the longer distance can be reached.
=== Parameters for working mode EC11 ===
{| class="wikitable sortable"
|-
! Mode !! average standby current !! delay ms (Send one byte)!! close loop test time 1 (ms) (baud rate 9600, send 1 byte) !! close loop test time 2 (ms) (baud rate 9600, send 10 byte)
|-
| EC11-M1 || 3.5 ma || 20 || 31 || 31
|-
| EC11-M2 || 80 ua || 380 || - || -
|-
| EC11-M3 || 22 ma || 2 || 8 || 18
|-
| EC11-M4 || 22 ma || 7 || 22 || 40
|-
| EC44-M1 || 3.6 ma || 4-80 || 31 || 31
|-
| EC44-M2 || 80 ua || 500 || - || -
|-
| EC44-M3 || 16 ma || 4-80 || - || -
|}

== AT Commands ==
Pull Down the Set pin to GND to enter AT commands mode.

{| class="wikitable sortable"
|-
! Commands !! example !! Return !! Description
|-
| AT || AT || OK || status check
|-
| AT+Bxxxx|| AT+B4800 || OK-4800 || baud rate avaialble at 2400，4800，9600，19200，38400，57600，115200
|-
| AT+Cxxx || AT+C058 || OK-058 || Change frequency channel
|-
| AT+FUx || AT+FU1 || OK+FU1 || change working mode
|-
| AT+Px (only for EC44) || AT+P5 || OK+P5 || send the power transmission rate, vary from -1~20 dbm, input value available from 1~8.
|}
[[category: Sub-1GHz RF Transceiver]]

CC1101/SI4463 Wireless Module UART - Revision history

Chao at 18:47, 5 February 2020