Category:L298

From ElectroDragon Wiki
(Redirected from Category:L298N)

All Boards Reference Schematic


L298N Drive Module


Note for Use R2 Version

  1. When you drive voltage (the figure identified as 12V input, can accept the actual input range is 7-12V) to 7V-12V, they can enable the on-board 5V logic supply
  2. when using the onboard 5V power supply interface, the voltage of + 5V power supply do not be used as input, but can use as output 5V
  3. When the drive voltage is higher than 12V, less than or equal 24V (chip can support manual proposes to 35V, but according to the experience of the general application of a conservative 298 to 24V maximum voltage support has been very great!), For example, to drive a motor rated voltage of 18V. First, you must unplug the onboard 5V output enable jumper caps. And then supply 5V into the output port.
  4. 5V enables a level of control that is 5V signal when the signal input is active, and the power supply is normal, the motor drive module motor drive module output current. Otherwise, even if the power supply is normal, and no current to the motor. L298N internal voltage logic circuitry. (This is a high-voltage driver unconventional application!)

Drive DC Motor

L298N Can driver 2 channel DC motor, stepper motor, EN, IN1 and IN2 is active on high level.

  • EN can be used PWM to move step by step
  • IN1 and IN2 can be used to control direction
ENA IN1 IN2 Motor Status
0 x x stop
1 or PWM 0 0 brake
1 or PWM 0 1 clockwise turn
1 or PWM 1 0 counter clockwise turn
1 or PWM 1 1 brake

Arduino Motor Shield R3


Arduino Self-balancing Stabilizer Shield

Pin Map

Arduino Pin Description
D0 D0
D1 D1
D2 CNTA1
D3 CNTB1
D4 CNTB2
D5 CNTA2
D6 Buzzer
D7 IN1
D8 IN2
D9 ENA
D10 IN3
D11 ENB
D12 IN4
D13
A0
A1
A2
A3
A4 SDA
A5 SCL

Hardware

The jumpers have two sides – A and B. You can choose the serial communication object of XBee module by setting the jumpers. When choose A side, you can make the XBee module communicate with Arduino via serial port; when choose B side, you can make the XBee module communicate with PC via serial port, namely, you can use PC to configure XBee module.

Documents

  • Read more information about the working principle on the page Motor

This category currently contains no pages or media.